ukVac.com Homepage
Forum Home Forum Home > Pinball > Technical
  New Posts New Posts RSS Feed - Bally Williams system 11c Power pcb
  FAQ FAQ  Forum Search   Events   Register Register  Login Login

Skin:


Bally Williams system 11c Power pcb

 Post Reply Post Reply
Author
Message
SUPERSPRINT View Drop Down
Senior Member
Senior Member
Avatar

Joined: 31 Jul 2016
Location: Devon
Status: Offline
Points: 865

Feedback: 5
Post Options Post Options   Thanks (0) Thanks(0)   Quote SUPERSPRINT Quote  Post ReplyReply Direct Link To This Post Topic: Bally Williams system 11c Power pcb
    Posted: 20 Aug 2018 at 7:23pm
Just wanted to share a little fix I did today, no photos but could help someone out.
Basically I picked up a Bally Williams 1990 radical pinball and the 2 Displays were dead. No activity on them, no voltage present. Was pretty annoyed as I thought I’d have to spend out on 2 new displays which are not cheap.

Tracing the loom I went back to the power board where the + and - 100v is generated for the displays. I recapped the pcb and result was a faint and random display. Reading through the manual it suggested replacing R1 and R4, both 39k ohm 1 watt resistors.

Swapped both resistors out and now the displays are like new.

Totally Rad.

Edited by SUPERSPRINT - 20 Aug 2018 at 7:27pm
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down



This page was generated in 0.141 seconds.