Bench power supply

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,029CR
I use a N93CX which is usually Maplin branded, when I can't get away with using the switcher in my supergun. Can be had for £30 - £50 when they come up. Very much an entry level power supply you'll have to spend a bit more if you want something more fancy.
 

ArcadePCB

User
vacBacker
Credits
509CR
You can consider something like this: PCW 07A Laboratory power supply, 0 - 30 V, 0 - 5 A, but don't expect a high quality device for this price. I think this is very low end. Because you're not looking just for an arcade power supply, but different voltages are required, you'll need a laboratory power supply. If you need more than one voltage the same time, you need more than one or a double power supply.
It also depends what you are fixing - a switching power supply is not recommended when working on devices hamdling very small analogue signals. On the other hand a linear power supply is not recommended when very high currents are required. So every type of power supply has pros and cons.
 

TheDaddy

Senior Member
vacBacker
Feedback
14 (93%)
Credits
7,229CR
Depends what you need , I have a Maplins one that does 80% of what I need it to do that was around £100 ish (can get make model if needed but no clue if they still do them) , I also have a standard hacked PC power supply as you will never get the amperage these can do for the price. My only suggestion if making you own is to put some protection in (Although most ATX PSU's have built in protection).

Again depends what voltage and amperage you need & what your basic needs are.

Dave.
 

ArcadePCB

User
vacBacker
Credits
509CR
But one remark for using PC power supplies: most of them need a load on the 3.3V or 5V rail to work properly. So make sure you draw at least about 1A continiously when using such a power supply.
 

John Bennett

Senior Member
vacBacker
Feedback
10 (100%)
Credits
5,324CR
We use Tenma's at work. Cheapish and cheerful (although there's probably many that are close for the same price range).

You're better off NOT wanting to do arcade boards with one though as there's some monster PCBs out there, so you'll wind up forking out a lot more if you want 10 Amps to cover massive boards full of TTL (an R-type bootleg is over 6 amps!).
 
Top