Cap kit - cap questions

seanr28

Active member
Feedback
9 (100%)
Credits
319CR
Hello

Im trying to place an order for the following for a Hantarex MTC-9000

Code:
===========================
	
	---------
	Neckboard
	---------
	
	C201 - 22uf 50v
	C205 - 10uf 250v
	
	------------
	Main Chassis
	------------
	
	C6 - 47uf 16v
	C9 - 100uf 35v
	C14 - 47uf 16v
	C15 - 1000uf 16v
	C16 - 1000uf 16v
	C22 - 1uf 50v
	C23 - 1uf 100v
	C34 - 22uf 160v
	C35 - 22uf 25v
	C38 - 1uf 100v
	C42 - 4.7uf 50v
	C45 - 1uf 250v
	C54 - 22uf 250v
	C56 - 1uf 250v
	C57 - 1000uf 35v
	C58 - 10uf 50v
	C59 - 100uf 35v
Code:
Code:
the problem is that there are various types of each of the above caps, how do I know which type I should be purchasing please??   some say low impedance for example......
Code:
any suggestions on preferred / better makes etc would be appreciated.
Code:
Code:
thanks in advance
 

RaveN

Active member
vacBacker
Feedback
1 (100%)
Credits
1,325CR
It's not critical which ones you go for, and low impedance aren't mandatory unless specifically listed in the manual.

What I tend to do is list all the caps on Farnell, and then go for something like the Panasonic FM (or similar) range, that have decent impedance ratings and overall quality. 105oC with 2000hr+ are preferred, but again not crucial.

You only need to look at ripple ratings if you're going to replace the large cap in the power section.

Forgot to mention - Try to get replacement ones of the same diameter, so they sit better on the board - remember caps vibrate.

RaveN2015-02-02 10:30:57
 

seanr28

Active member
Feedback
9 (100%)
Credits
319CR
RaveN said:
It's not critical which ones you go for, and low impedance aren't mandatory unless specifically listed in the manual.

What I tend to do is list all the caps on Farnell, and then go for something like the Panasonic FM (or similar) range, that have decent impedance ratings and overall quality. 105oC with 2000hr+ are preferred, but again not crucial.

You only need to look at ripple ratings if you're going to replace the large cap in the power section.

Forgot to mention - Try to get replacement ones of the same diameter, so they sit better on the board - remember caps vibrate.

that's useful advice, thankyou.

don't suppose anyone has a ordered list for the above from somewhere like farnel or alike do you please?
 
Top