cleaning up joystick balltops
- Thread starter agent4125
- Start date
mysticmonk
Active member
One handy little tip, stick the actual joystick in drill, then cup fine sandpaper in your hand and spin away, nice and even. Same for polishing.
Beside that, the colour may be destroyed. Maybe someone else can chime in there.
Beside that, the colour may be destroyed. Maybe someone else can chime in there.
http://www.ukvac.com/forum/this-arrived-today_topic333532.html
Ask Dex-jay what he did mate, bottom of page 1 here. I saw it the other week again and thought
Watching some of the programmes like repair shop, salvage hunters the restorers, who would of thought you could restore a film poster in bits, need to watch that fully still but it shows you that nothing is junk and should be thrown out, would think that lot of sticks was fit for bin and yet they look like new after, lesson dont dump anything without looking
Only thing you cant repair is glass reallyBods2021-09-10 18:08:14
Ask Dex-jay what he did mate, bottom of page 1 here. I saw it the other week again and thought
Watching some of the programmes like repair shop, salvage hunters the restorers, who would of thought you could restore a film poster in bits, need to watch that fully still but it shows you that nothing is junk and should be thrown out, would think that lot of sticks was fit for bin and yet they look like new after, lesson dont dump anything without looking
Only thing you cant repair is glass reallyBods2021-09-10 18:08:14