Cocktail Screen Issue

Chopper79

Active member
Feedback
8 (100%)
Credits
668CR
Got the following screen, on a cosmic alien cocktail. It's got a universal to jamma connector, with a 60 in 1. It's only distorted on one side of screen. Degaussing works, but doesn't resolve. Colours are spot on. No amount of adjusting chassis pots, resolve issue. Could this be a cap issue?

20220616_119.jpg
 

Chopper79

Active member
Feedback
8 (100%)
Credits
668CR
This is it I think? I haven't touched it, as thought it might be pre set. Looks like it needs an Allen key for adjustment.

20220616_171000.jpg
Chopper792022-06-16 17:14:02
 

Chopper79

Active member
Feedback
8 (100%)
Credits
668CR
Grant your a star! While the Allen key is in the slot, is messes up the graphics. Only shows pic when allen key removed. It think it shorts on the can? Still can't adjust the up and down? There is nothing to adjust it.
 

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
V hight would do the width in Tate mode?
Clean internals !

Slightly out on the hori sync?

Or yoke not quite 90 degrees to back of tube?
Magnet dropped of back of tube?
You could try pulling it back with some
Weak magnets?
Retroman8392022-06-16 22:04:47
 
Top