Connector Identification

digweed

Active member
Feedback
15 (100%)
Credits
368CR
I know this may sound dumb but I have no idea where to get this connector as have no idea what it is called. It is to power up a Pentranic 29" VGA monitor on my Naomi. Swapped monitors and the other had a male connector, I now need to change this to this female connector. There is an exact connector on the other side of the chassis which I have taken a picture of. Can any help this dumb one?

Monitor_wire.jpg
 

yorkshire_spam

Active member
vacBacker
Credits
765CR
Is it round or square pins? Can you measure the "pitch" between the pins (centre to centre distance) and the width/diameter of the pins?
 

digweed

Active member
Feedback
15 (100%)
Credits
368CR
Thanks

It's square pins, the width/diameter of the pins are 8mm. Not sure where to measure the pitch. Is that the distance in between the two pins?

Monitor_Power.jpg


digweed2021-08-12 14:07:22
 

yorkshire_spam

Active member
vacBacker
Credits
765CR
Pitch is sort of the distance between the pins it's actually the distance between the centre line of 1 pin to the centre line of the other. This can be measured easily by measuring from the left side of 1 pin to the left side of the other (or right side) but not "inside to inside" or "outside to outside"

pitch.png


Green measurements are the pitch, red ones are "almost right, but not quite"
 

digweed

Active member
Feedback
15 (100%)
Credits
368CR
Okay sorry I got it all wrong then smh

The pitch is 7/8 mm and the width of the pin is 1 mm if that makes sense

digweed2021-08-12 17:37:54
 

digweed

Active member
Feedback
15 (100%)
Credits
368CR
M K L said:
The connector in the first pic must be for the degaussing coil, not power. It's a JST V:

https://www.jst-mfg.com/product/detail_e.php?series=258

The second one is for power, JST VH:

https://www.jst-mfg.com/product/detail_e.php?series=262

Thanks it has pointed me in the right direction. You are correct in saying the first pic is for the degaussing coil but it is the same size I am looking for.

It looks like I'll need a 7.92mm JST VH connector

Thanks for all the help, now just need to find one I can order as I think they come in multi packs
smiley20.gif
 
Top