Cps2 replacement back up battery

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
Just wonderd if you guys think this is ok
For using in the cps2

IMG_0727.png

IMG_0728.jpeg

Looking to grab a few so looking for a good price and this price looks good ..
But does this battery look to be ok ?
 

Lurch666

Active member
Feedback
21 (100%)
Credits
4,506CR
The battery keeps the volatile code in the board to stop piracy,if removed I think the code disappears rendering the cps dead.
If you replace the roms with pheonixed ones or fit an infinikey that will get the board working again but at that point the battery is pointless.
 

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
Been doing the battery with the taridian
3.6v 1/2 aa axial normally on my boards ..

But I noticed the saft type is being used by others and seems to be a little easier to buy …. Just wonderd what others out there are using ?

Seen the holders too but I don’t trust them stopping the little batteries falling out
 

chris2922

Active member
Feedback
1 (100%)
Credits
333CR
Neither… or either. It’s so you don’t have to keep changing batteries (unless you enjoy changing them). Phoenix roms make the battery redundant. They don’t change the game.

Some people prefer their boards ‘original’ but once you’ve changed the battery they aren’t original so I can’t get onboard with that way of thinking. Any way to get battery acid away from fragile boards has to be a good thing.

The only difference you’ll notice is during boot is it will show the phoenix rom version instead of the usual CAPCOM information.
 

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
Not sure how long these new batteries
Last but if darkstalkers ws made in 1994 the maxwell lasted 30 years .

But obviously some dont last -
I just haven’t had a non working cps2 board before and all the boards I have
Had all where on original batteries.

This darkstalkers was at 1.9 v
So it was getting dodgy
 
Top