Flyback replacement help

[jerryspaghetti]

Need to fit a new flyback to a Sanyo ez20 but the white (neck board) cable on the replacement is only about 4 inches long. Need a good 10 inches (wink) to be able to reach.

So my question is, can I just solder and heat shrink my new flyback cable to the existing white cable I’ve cut from the old flyback or will that cause problems?

I’m guessing it’s as simple as that but can never be too careful with irreplaceable monitors!!

 

[gunblade]

er what wire?
the wire that goes to the focus block?

 

[jerryspaghetti]

Right, im a numb nuts. Didn’t clock that I re use the pots/Mount from the old flyback.