Fruity Problems

Fuccawallaby

Newbie
Credits
1CR
I was successful today in teaching my coin mech the new pound coin, i also ran a test through bulbs etc, then the sound went squiffy, sounded like chipmunks and then no lights or sound, although there is power lights on circuit boards and machine noise, everything was working perfectly until then. Checked for obvious loose connections, there was a brief breath of life, but could not b replicated. Its a Global Spotted Dick. Any help would be greatly appreciated.
IMG_0751.JPG
IMG_0760.JPG
 

obcd

Active member
Credits
3,830CR
Make sure all supply voltages are present. Sometimes 5V is enough to run the game, but you need 12V for the sound amplifier and the lamps. In such case, the 5V led will light up but the 12V (if it exists) will not. If the bulb test turns on all bulbs at the same time, the supply and the connections are pushed to their maximum as the current is maximal. If there are a lot of lamps, they can be driven multiplexed on 36V or 48V
 

Fuccawallaby

Newbie
Credits
1CR
Thanks for the suggestions so far, much appreciated. Out of interest, i switched it on tonight after 24hours and it came straight on. ran a test £5.00 through it and appeared fine. Put in test mode went through tests, but when shut door, did not come out of test mode. Then we switched off at wall, then came back in same dead state, lights on boards but nothing else. So this may indicate a different root cause to the problem? Battery and memory maybe, really no expert on this.
 
Top