Harness Wiring

bouncylj

Newbie
Credits
3CR
Hi there,

still pretty new to this, i'm trying to wire up a JAMMA Harness for a super gun, and i had a few questions,

Firstly do i need to wire up all the power connections or just the ones for the board i'm using?

so for my MVS Board do i hook up +5 +12 -12 and -5, or just +5 + 12?

also i ordered a JAMMA loom, and it came with a 36 pin connector, what the hell is that for?

sorry if theses seem dumb, i've had trouble finding answers from just looking around.

Ta
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
You should wire up all ground, +5v, -5v and +12v pins, boards that don't need -5v for example won't be wired up to use it so it won't cause an issue. Never wire up -12v, it's not required for jamma.

Do you mean that the harness has a 36 pin edge connector instead of a 56 or it has 56 and 36?
 

bouncylj

Newbie
Credits
3CR
well as far as i can tell, it had 36 pins so it would total 72, i discovered it when i went to check it on my one slot and it physically wouldn't fit, if that makes sense
 
Top