Help to identify this header/plug type

chris2922

Active member
Feedback
1 (100%)
Credits
333CR
Hi can someone please help me identify this header/plug type?

I need to make a lead that will plug into this but I havent come across it before. It has a little lip like a JST connector would use, but the spacing is different.

4pin_header.jpg


It is supposed to be a connector for a CPU/GPU fan but its way too big!
 

bones

Active member
Feedback
15 (100%)
Credits
1,628CR
Looks like a common medium molex housing,pitch should be 2.54mm. There's probably other makes out there but try searching that as they're still used quite a lot.
 

chris2922

Active member
Feedback
1 (100%)
Credits
333CR
The distance between the centre of the pins is 3.6mm according to my callipers.
Distance between the pins 2.8mm

I tried a Molex KK lead from eBay (shot in the dark) but the pitch was too small.chris29222022-09-03 10:41:10
 

FrancoB

Active member
Feedback
16 (100%)
Credits
1,040CR
Had a dig through my parts and found some 4 pin JST NH parts:

i-kJW2ZPF-L.jpg


Do I win a prize?
smiley17.gif


Let me know if you need a housing + contacts. I can always make up a cable if you need it. What's going on the other end?
 

chris2922

Active member
Feedback
1 (100%)
Credits
333CR
Thanks for confirming that, I have been going round in circles. Exact match by the looks of it:
4pin_header_pitch.jpg


I am working on a GPU fan management solution. So this 4 pin header needs to connect to a 3 pin standard fan. My plan was to find the right connector (which I now know is JST NH) and then make a lead that is JST NH on one end, and chop the end off a fan extension cable and solder the wires together so i can plug a fan into it.

Housing and contacts would be great if you dont mind.

chris29222022-09-03 11:32:17
 
Top