Help with Bubble Bobble original

TheDaddy

Senior Member
vacBacker
Feedback
14 (93%)
Credits
7,230CR
I’m not keen on swapping customs about just in case there’s an issue which breaks the working one and then I’m in for 2 non workers.

Swapping cpu and video boards is a good shout though

Didnt realise you had another. I would just do what you can and are confortable with. Main thing is voltage but unlikely be that as both you and original owner have different PSU's. Other is to remove and clean each chips , IPA and reseat. Cross both fingers and power up.

Dave.
 

lix

Active member
vacBacker
Feedback
1 (100%)
Credits
546CR
Common fail points I've found on Bubble Bobble pcbs are the 24Mhz clock oscillator module on the video board, the 74S74 / 74LS74 flip flops which divide the 24Mhz down to 12Mhz & 6Mhz which are immediately connected to the clock oscillator at the top left of page 7 of the schematics.

The next possible candidate is the reset generator IC (Fujitsu MB3771) at location 19 near the PS4 custom chip on the cpu board.

Obviously it could be anything else but I'de personally look at all inputs and outputs of any Fujitsu chip on a scope if there are any others.
 
Top