Help with custom PSU

G

Guests

Guest
Can anyone help me?

I'm building a test PSU for my Ridge Racer cab. It's a PC PSU which are commonly used to replace original Ridge Racer PSU's.

I've got all the excess wires removed (3.3v etc) however I've got these:

2016_09_26_17_30_07.jpg


-12V and +5VSB... what are these? do i need them for my PCB? What is the best course of action for these and what do they do?

Also, I have this:
2016_09_26_17_30_17.jpg


Green and grey wires which control the power on of the PSU. When you want to start a PC without a power button you tap 2 jumpers on the motherboard which boots it and starts the PSU. I'm assuming these wires are just an extension of this so all i need to do is bridge these so it will power on when the PSU receives power from the mains (with the switch on the PSU on).

Any help appreciated.
 

obcd

Active member
Credits
3,830CR
Can't help you with the -12V, but the 5VSB is the 5V standby voltage. It has 5V and can only deliver minor amps, even when the supply isn't turned on. It's used in pc's to allow the system to turn on the supply on occasions like a button on the keyboard or a special packet on the network (Wakup on lan) To turn the supply on, you have to connect 1 wire to GND. To figure out which one, you can take the manual of a modern pc motherboard. It usually describes the power connector and all the wires and their function. Besides power on, you also have a "pwr OK" wire that is a return signal from the power supply to the motherboard. It indicates that all voltages are present and within acceptable range. So basically, a pc pulls the PWR ON to gnd to turn on the supply and waits for the "pwr OK" before it releases the reset and starts to boot. Most supplies simply turn on if you tie the "PWR ON" to GND and ignore the "pwr OK" Modern game boards only need +3V3 +5V and +12V. Older ones needed -5V as well.

So, just check the desnitation of that green and gray wire, and check on a pc mobo power connector what they are used 4. One of them might be PWR ON, but you should connect it to GND and not to the other.
 
G

Guests

Guest
Thanks very informative.

I've put PC ON to ground and removed the pwr ok wire.

2016_09_26_22_07_20.jpg
 
Top