Hi
Recently picked up a Beharbros Hayabusa supergun, but i think its the original one with old firmware.
It will only recognise official PS1 controllers, and apparently there is a lag issue.
I've tried contacting makers, but no response
I know where to get the firmware and I just got hold of a USBASP needed to do
but after that I'm lost.
I assume the USBASP goes from PC USB and i have to put dupont leads on the correct pin to pin on the supergun
does it need to powered at this point?
never done this before
any ideas?
Recently picked up a Beharbros Hayabusa supergun, but i think its the original one with old firmware.
It will only recognise official PS1 controllers, and apparently there is a lag issue.
I've tried contacting makers, but no response
I know where to get the firmware and I just got hold of a USBASP needed to do
but after that I'm lost.
I assume the USBASP goes from PC USB and i have to put dupont leads on the correct pin to pin on the supergun
does it need to powered at this point?
never done this before
any ideas?