Hyper Olympic Repair

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
I obtained a Hyper Olympic PCB in need of repair. I think there must have been a significant short on the PCB because it has taken out a large number of components that all 'link' up. After a fair amount of work I've managed to get the PCB booting fully with the test ROM chip - passes all tests that the chip is capable of doing. Sadly, it looks like it has repaired with the test ROM, but oh no.

When you put the standard ROM chip back in the PCB resets with zeros all over the screen. There is still a lot of inactivity on one side of the PCB. Life wouldn't be right though without crap schematics and T & F is no exception.

I'm looking at the following:

T_and_F_2128.jpg





What looks to be 2128 chips on here (no board position). I've confirmed that pin 4 of 5G hits pin 21 of 11H but what looks like pin 8 doesn't hit either 10H or 11H. I'm trusting that the inputs to what I think are those 2128s are good but I'm getting no output activity from either.

Are the chips located at 10H & 11H the 2128s and are these RAM? Konami have helpfully scratched off the chip ID. I don't believe this will be the end of the boards shorted woes - but it will bring me closer to fixing it.

DSCF9513.JPG


Any help greatly appreciated.
 

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
Thanks

Yes, that's the screen I'm getting.

The battery has also been removed (but I didn't think that would have been an issue).

The RAM chip adjacent to ROM 5 has been removed and socketed with a dreaded turn pin. Now that I know what that chip is I can place a known worker in there and see what happens.

I'll have to check this one out before reporting back and I think and more than likely I'll have to order the RAM.
 

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
Fixed it, with RAM thank you sooooo much.

It was the socketed NVRAM next to ROM 5. The original chip was in there but had no markings on it like the other 2 at 10H & 11H. I had a spare 6116 which I placed in socket and the PCB fired up. Just need to put a battery holder in there to fix the high score corruption.
jonhughes2017-09-16 09:54:25
 
Top