k7000 vertical issues

Slimo

Newbie
Credits
1CR
image_50739457_small_.JPG
image_67200257.JPG
image_67504129.new.JPG
image_168170241new.JPG


Hello, this is my first time posting on this forum and I'm wondering if anyone can shed some light on my issue. I am no stranger to repairing electronics and I always like a challenge. however this issue I haven't been able to repair yet so before I go insane staring at the schematics...

This is a 1990 revision on the 25K7000 monitor. I will attach pictures of the circuit board and what the screen displays. this is the best I have been able to get the screen with all adjustments however I am wondering if I have missed some silly adjustments?

To start with I probed the B+ and pin 6 on IC3 both turned out to be pretty good, IC3 being 25v not 24V. As it follows I replaced IC3 along with C50 and as I was replacing C50 I decided to recap the whole board to give it its best efforts. This gave no joy and I still had the exact same results, then I targeted the video sync circuit and replaced Q9 with a BC548 which should be a suitable replacement (providing it is turned 180 degrees for the pin out to match). with no joy I substituted IC2 with one off of another board (unknown condition). with no joy again I decided to reflow the board paying particular attention to the remote board wires and the pots on the remote board, and since it still had a white knob fly back although it only had one minor crack I swapped it out for the new black knob style one I had. Testing the board again wielded the same results.

I remember watching a video a while ago where someone said they found C53 and C54 to give vertical issues, has anyone heard of that before?

If you have spotted something I have done wrong or something that looks amiss could you please let me know.

Thank you, Slimo.

k7000.png_new.JPG
 

Slimo

Newbie
Credits
1CR
The 50/60hz circuit seems to be working, I can adjust it to get a clear picture and back again but it is still small like it has been, thank you for your reply
 
Top