LED Seimitsu Buttons

Strizzi

Newbie
Credits
1CR
Hi guys!

As you can tell I just entered this forum and really hope this is the right place to ask.

On a whim I bought 8 seimitsu-psl-30n-5w2-5v illuminated buttons from arcadeworlduk. The only "modding" I did to my arcade stick was change the color of my buttons and create custom artwork.

I didn't notice that those buttons had just bare wires at the end to connect, so now I'm asking:

Is there a LED Board I can buy to connect those, that will still do plug&play on the ps4?

I use a Madcatz TE2 to play fighting games and my local scene only uses ps4's. I Only found LED boards that work on PC/PS3.

Hope the question wasn't too all over the place.
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
if its a PC arcade Stick then you can use a PACDRIVE, but it will only work when the software to control it is also running and its connected to a USB

if its being used on a PS4 or XBOX then the only thing you can do is connect the red wire to +5 and black wire to GND of the USB to get a constant light up
 

Strizzi

Newbie
Credits
1CR
First, thanks for the fast reply.

I mainly use the arcade stick on the ps4 so the pacdrive is not an option. The constant light up is what I am going for anyway so that wouldn't be a problem.

Could you explain that to me in layman terms or direct me to a tutorial? I'm basically a complete beginner when it comes to advanced stick modding. +5 and GND are parts of the usb connection right?
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
yes thats right Pin 1 of the USB is +5 and Pin 4 is GND

although one thing to mention here is the power draw

USB ports are usually only 500mA (2W) and USB3 900mA (4.5W)

so you need to look into weather the draw may hurt your PS4

i dont think it will be an issue as long as you make sure the inline resistors are the correct value

that you will need to check with the datasheet of the buttons

silverfox07862016-10-14 13:29:37
 
Top