Monitor blank screen

Shinydaz

Active member
vacBacker
Feedback
6 (100%)
Credits
814CR
Ok, so I took the plunge and discharged crt and removed chassis. I took a few pics of the board.
IMG_20150729_3687.jpg
IMG_20150729_2825.jpg
IMG_20150729_18252.jpg


Also I noticed the blue wire going to the tube moves up and down in the plastic holder, I assume if it is well connected to the wire it's soldered to, it's all good, just loose in the plastic holder?
IMG_20150729_43263.jpg
 

obcd

Active member
Credits
3,830CR
Assuming something is never wise when you are dealing with electronics. Just follow the wires to the monitor chassis and unplug them there. Measure with an avo meter on position ohms. If you measure a low resistance, the wire is connected and it should be fine. If you measure close to infinity (high resistance) it's time to examine things closer. You might need to remove the black shrink tube for that.
 

joe65

Newbie
Credits
3CR
Hello guys,

I´m new to this forum, but know some about monitor repair. First I would clean the thing a little bit more. And get brightness back - otherwise you could have a damaged screen mask later on.

It´s a horizontal deflection problem the screen shows. The line goes over the hole screen (top to bottom)- this means HV voltage is present, but there is either a short (transistor, diode, capacitor etc.) in the horizontal deflection unit, or a loosen contact on the pcb, connector, burned resistor or cable.

Is there a schematic diagram available? Please post if possible. Can tell you more then where to measure...




Joe
 
Top