Monitor Choke Identification

PhilT

Active member
vacBacker
Credits
154CR
I am recapping a monitor chassis and noticed that one of the chokes was bent over so I pulled it out to get a better look and promptly dropped it onto a tiled floor; now its actually broken in 2!

Anyway I need to source a replacement but am a little confused by the markings.

Its a Naneo 26inch tube (from Outrun), I think an MC-2000S chassis.

The manual says:

L506, L-CHOKE (300uh) Part no - 4F16078AA

But the part has this printed on the top:

301KH

And looking at the parts available, it seems I cant actually get a 300uh choke, they are 270 or 330.

Like this one:

http://uk.farnell.com/panasonic-electronic-components/elc08d331e/choke-330uh-10-0-5a/dp/2309766

Can I just drop in a higher or lower valued one?, theres also another one beside it with the same markings so should they both be replaced so their values match?

One day I do hope to know what I was doing...

Thanks.

Phil
 

obcd

Active member
Credits
3,830CR
It depends where it is placed in the circuit. Besides it's value, you also have to check the current it is designed for. A higher current rating shouldn't be a problem.

Sometimes, coils are just used on supply lines to suppress ripple and RF interference. In such case the value isn't critical and you should pick the next higher available value (330uH)

If you could just point to the proper schematics, I am sure someone will be able to give you more accurate information.
 

singy1uk

User
Credits
119CR
301 = 300 the 1 being the multiplayer (number of zeros) k is the tolerance +/- 10% the H is for unit of measurement (micro Henry).
 
Top