Monitor/CRT frame compatibility?

Mitchell Gant

Active member
vacBacker
Feedback
2 (100%)
Credits
888CR
I have a shortage of metal monitor mounting frames compared to the chassis and CRT's that I have and was wondering how compatible different monitor frames might be, for the same size CRT of course.

For example, I have a couple of Electrohome GO7 chassis boards and a couple of CRTs to suit them, but nothing to mount them in. Would the 19" CRT bolt directly into, say a Hantarex 900 or 9000 frame? I realize that the chassis board would not fit directly, but that may not be too difficult to adapt. With gaffer tape and Blutack perhaps.
smiley29.gif
smiley36.gif


Same goes for a Tatung 20" CRT and chassis I have with no frame, could that easily fit another 20" frame?

Or are all same size CRT's different enough from each other that they can only fit the original frame?

I'm after 2x G07 horizontal frames, a Tatung 2040 frame and a WG6100 frame if anyone has those for sale. Though postage of such items is obviously a bit of a problem.
 

tb lilley

5 Star
vacBacker
Feedback
2 (100%)
Credits
1,686CR
I've swapped quite a few tubes, either between different models of monitor, or from TVs. As long as the tube is the correct size on the diagonal, then never had any problems with fit. I even once managed to shoe horn a 20" tube into a GO7. Not pretty. And not properly secured.

Electrohome and WG frames are very easy to send by post. Just need to undo a few screws/bolts and they come apart into 3 pieces and can be flat packed. I had a 6100 frame sent to me that way from the U.S. Hantarex are much more difficult to post as you can't really break them down the same way - but I have had one delivered in the past.
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
Like Mr. TB says 20" tubes into 19" chassis? Maybe.

But if you can weld and have use of a grinder 20/21" TV tubes in 19 WG chassis - defo!
Even if the rest is scrap it's worth keeping (hoarding) chassis. - They's gold.
smiley1.gif


teev.jpg
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
Ghetto indeed! Cheeky monkey!
smiley36.gif


I tried plan A - cap kit, flyback and another couple of parts. Anymore was totally out of my technical abilities. So plan B. £5.00 TV it was.

ttt.jpg
 

Mitchell Gant

Active member
vacBacker
Feedback
2 (100%)
Credits
888CR
So your new 20" CRT has same width mounting holes as the 19"frame but you had to weld an extension to top?

Looks great. No gaffer tape or Bluetack in sight.
smiley36.gif
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
I had to add little folded pieces, weld and then re-drill.

No blue-tack (or chewing gum) and I ran out of sellotape otherwise I would have used that.
smiley2.gif


You got that MIG all sorted out and flying or is this the last step?
 
Top