Name that loom...

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
See what I did there
smiley2.gif


Following Alpha1's recent mega sale I now have the below Atari wiring loom that I'm planning on adapting for our Star Wars shell project into it's new wiring loom, but think if I can ID the original loom game then I should have an easier job of moving the pins around to the right places

Lots of pictures below and if anyone with a keen eye can identify it, and some of the connectors later on that would be much appreciated!

IMG_2222.JPG


22 x 2 board connector

IMG_2223.JPG


15 x 2 pin board connector

IMG_2224.JPG


IMG_2225.JPG


IMG_2226.JPG


IMG_2227.JPG


IMG_2228.JPG


IMG_2229.JPG


IMG_2230.JPG


IMG_2231.JPG


IMG_2232.JPG


IMG_2233.JPG


IMG_2234.JPG
 

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
Looking at the part numbers for Centi, Milli, CC & MC, its not one of those, there is a chart here with some of the harness numbers:

https://www.flippers.com/atarilist.html

Found a thread with your one mentioned...
http://forums.arcade-museum.com/archive/index.php/t-214951.html

A040467-01 - I think you might have lucked out and have a Star Wars part there.
 

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
Bensonrad said:
Found a thread with your one mentioned...
http://forums.arcade-museum.com/archive/index.php/t-214951.html

A040467-01 - I think you might have lucked out and have a Star Wars part there.

Almost!

The photo on the For Sale thread was one I found showing a Star Wars harness with ID A040467-01, the one I have is:

A040475-01

So very close, but perhaps a game released just after?

I've checked Tempest and that is A03775-01 and A037777-01 (power harness) so something after Star Wars in production terms

Good spot!




Yes the photo I didn't include is the one Alpha1 took which shows A040467-01 as the Loom ID, and actually I've just noticed that if you look at the second set of text it says...




ATARI

A040467-01

REV.A BSTWPO9




which I would imagine means STW = Star Wars so I think that really might have been a super bit of luck!




Cheers guys
smiley32.gif


AtariStarWarsLoom.jpg


Star_Wars_TM-225_2nd_Printing_Page_43.jpg


Judder2016-05-16 17:30:47
 

Judder

Active member
Feedback
2 (100%)
Credits
1,009CR
So I'm studied this some more, and it's pretty close to the Star Wars one as far as I can see, so I think I should be able to meter it out and work out what should be going where

Anyone got any close up photos of their Star Wars cabinet wiring I can use for reference (*along with the schematics but they are hard to follow as everything is labelled non-sequentially)?

Loom

IMG_2223.JPG


Star Wars

StarWarsHarnessUS.jpg


StarWarsHarnessUS2.jpg


StarWarsUSHarness3.jpg
 
Top