Odd voltage on Atari Xevious

virtvic

The Cabaret King
Feedback
21 (96%)
Credits
2,012CR
I've just acquired an Atari Xevious pcb.

I need to make up a simple loom to just check it out, but there's an odd voltage of 10.3vac unreg on pin E

Can I get away with 12v dc on that line or miss it out altogether? I'm guessing it's for something that's not really needed?

smiley5.gif


My old Namco board just used a Galaga pinout!
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
sure its not 10.3 DC? this is common to atari PSU's of the era.

id trace what it feeds into, hopefully a more knowledgeable soul will give a better answer ;)
 

cliff_poole

Active member
vacBacker
Feedback
6 (100%)
Credits
1,069CR
It is DC and is part of the power on reset circuit. Not terribly critical.

I used the 12V line but fed it through three small signal diodes (each should drop the voltage by about 0.5 to 0.6V).
 
Top