Outrun voltages

cosine

Active member
vacBacker
Feedback
14 (100%)
Credits
595CR
As you may or may not know, I was getting black screen/reset issues with mine, sent the PCB down to Mark Haysman, and he didn't find any faults. I got it back and it ran for a few days, until this morning after putting the enhanced ROMs back in, it started the black screen shenannigans again. Went back the original ROMs, same problem.
Went in the back of the cab, to see if something was shorting out, and found a pair of pliers I thought I'd lost years ago
smiley9.gif
, but nothing out of the ordinary. I have now tweaked the 5v slightly, and so far so good..

So my question is to the peeps who have Outrun, what is the 5v set in your cab?
 

Outrun2

Colonel Outrun
Feedback
5 (100%)
Credits
1,181CR
I think mine is 5.2v at the board.

Any less than 5v and you will get reset issues. If it's 5v at the switcher then it'll definitely be too low at the board.

Hope the tweak keeps it (out) running smoothly
smiley17.gif
 

cosine

Active member
vacBacker
Feedback
14 (100%)
Credits
595CR
jengineer said:
I also had an Outrun that had graphics issues and it turned out to be the psu
Yeah, that's playing on my mind, since I haven't touched the 5v adjuster for years..
Anyway, it's been running solid for 4-5 hours now, and even did some "test runs"
smiley9.gif


q390QoY.jpg
 
Top