Point Blank 2 - Gun Problem

Bobba

Newbie
Credits
10CR
Hi,
I’m having trouble getting the guns to work on my Point Blank 2
(running on system 11 - 3 board stack! but not sure if it’s an original)

I’ve had the machine for 5 years and it has run fine, then both guns failed within a few months of each other.
Now the shot is acknowledged only by a blink on the screen and ammo depletion.
I can’t get access to the Calibration screen, I’ve wired to jamma test 15 and service b like many other boards, but nothing even happens.
Also it has a hantarex polo 28” which I’ve wiped dust off and also checked the brightness level.
There is also a large Hantarex PSU inside

Any ideas on trouble shooting or getting the test page open?
Cheers
Bobba
 

pooman2084

Be Attitude For Gains!
vacBacker
Feedback
26 (100%)
Credits
1,886CR
Is there anything inside the coin door? Look for the volume pot and the switches should be nearby.

Just to be sure you connected the test switch to ground? The manual suggests it needs to be latched on to make the adjustments.
 

davey d

Active member
Feedback
2 (100%)
Credits
480CR
If the screen flashes, and you lose ammo when pulling the trigger, then the game is picking up that the trigger is being pressed (button input) but the gun isn't picking up the flash that the screen is displaying. Have you tried cleaning/ polishing the lens in the end of the gun? Or checked for any damaged wiring in the gun?
 

Bobba

Newbie
Credits
10CR
Is there anything inside the coin door? Look for the volume pot and the switches should be nearby.

Just to be sure you connected the test switch to ground? The manual suggests it needs to be latched on to make the adjustments.
Only a bundle of wires from the loom.
I did trace them back and it all to coin mech on the JAMMA, nothing to the test or service. I also attached switched to them all and tried various combinations to get to the menu but nothing at all (3 switches in total all G)
 

Bobba

Newbie
Credits
10CR
If the screen flashes, and you lose ammo when pulling the trigger, then the game is picking up that the trigger is being pressed (button input) but the gun isn't picking up the flash that the screen is displaying. Have you tried cleaning/ polishing the lens in the end of the gun? Or checked for any damaged wiring in the gun?
Tried all except opening the guns up.
Is there a known component in the guns that fail?
 
Top