Pole Position tech links

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
it arrived but no instructions so no idea how to use it I will get web searching

this is the one not sure if it will do all I need:

http://www.ebay.co.uk/itm/Logic-probe-/171871917196?hash=item28045d548c
 

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
update

I worked out the logic probe, all chips shown in 12b are functional as in no dead readings, there were some legs set to high but like you say RGP that could be normal

but I need to ask this:

identical chips at 3k and 3l are the same chip type - stupid question but.... I don't know their function, will they behave identically in their output as I found differences between them [ eg some legs on one set high when on the other hi low and pulse all active same time], when on other different chip type pairs I checked they seemed to follow a similar pattern

have I found the, or a fault?
 

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
my posts are betraying my lack of knowledge, I will try to update when I find out more now rather than give a running commentary...

looked at schematics I answered my own question, I am guessing where it says 32h, 16h etc it means high just the input is different, I will do lots of reading and try to suss out how to use the probe to work it out but I managed to hook up the pcb on a stool so I can test away very easily with cabinet on, no need for a test rig!
 

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
ok was trying to avoid posting but this is exiting me so Ops go easy don't mean to keep on appearing in latest post window....

found one of the chips schematics:

https://www.physics.wisc.edu/undergrads/courses/fall2014/623/ds/74LS283.pdf

maths is not my strong point but I now understand the 2 chips can have different values in their inuts and outputs, they inter link also I think

it seems they process number crunching and are adders I think they are responsible for adding data and possibly controlling or helping to, the kerb section movement, either position overlaid into moving road or the alternate colours moving, but I am not sure

this is the challenge, a bridge too far for me maybe to go so far as to analyse the code as I don't program but at least I might learn how to understand what values should be at what legs

Gaming Heaven2015-08-13 23:36:10
 

Gaming Heaven

Active member
Feedback
6 (100%)
Credits
106CR
finally checked voltage at board

when looking from rear of cab:
5.15 v left side board
4.73 v right side board

also
noticed the monitor is definately clicking I am now going to google it,
once very few seconds, no sign of arching or anything visable, is this a
bad sign?!

...update....Google says yes but visually the monitor is fine apart from screen burn, nice picture

read on youtube:
a click is your over voltage circuit kicking in and shutting the chassis down
now a bad flyback could be the cause but these do not fail very often
you have capacitors and voltage regulators in that circuit that are much more likely to be your cause

can I swop this monitor out for any compatible voltage standard res?
 
Top