Reading resistor

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
Please can I get a little help reading
This resistor for the red gun.

0A47F3FF-AEA7-405F-B907-5B9FBD0AB8C2.jpeg


It’s the different colour banded one with the chard legs.

I don’t want to match it..
I waNt to swap it out with the same resistance of the two next to it.

Which I believe Is. 5600 ohm 5watt.

Green =5 blue =6 red =. X10 Gold +-5% tolerance.

I am also aware that the R791 on the pcb differs from the R962 on the schematic
This is the schematic I could find for pentranic ch-288
Not sure if it’s for a different similar chassis but it seems correct.

123074C4-42E8-453B-B62B-EFE7C25514CF.jpeg


Does this look correct?

And if I cannot get a 5 watt Can I use a 1 watt?
What are the tolerances that by which I can work with ?

Thanks for the helpRetroman8392022-05-28 08:38:29
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,084CR
I doubt 1w would be good enough. Use a 5w one. Sometimes white resistors indicate they're fusible, but body colour can vary between manufacturers.
 

Retroman839

Senior Member
vacBacker
Feedback
13 (100%)
Credits
8,288CR
big10p said:
I doubt 1w would be good enough. Use a 5w one. Sometimes white resistors indicate they're fusible, but body colour can vary between manufacturers.

Cheers will keep looking till I find a 5w

So I have a match from china.

£12 for 50 free post
R S only had 5600 ohm wire wound. 7w or 3w at bag of 5 minimum £1.88p each plus post.

I’m not on a rush so I opted for bag from china so if any wants free resistors 5600 ohm 5w
I will have about 40 spare in about 6-8 weeks
smiley36.gif
Retroman8392022-05-28 10:42:53
 
Top