Soldering is Easy: Comic Guide

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
Good guide!

soldering.JPG


"You will go insane and lose all of your friends...." - Friends? Sanity? You've lost me....
smiley36.gif
 

RGP

Meeter & Greeter
Feedback
5 (100%)
Credits
2,039CR
I especially love the comment about lead free solder.

Something we're told is better for the environment is more toxic and harder to work with than it's 60/40 counterpart.

Oh wait.... that's because it breaks down very quickly compared to proper solder causing failure which means you throw the device away and buy new thus fuelling a consumer economy......

(Sponsored by the campaign to abolish lead-free solder).
 

Dex-Jay

Active member
Feedback
4 (100%)
Credits
375CR
^^ (Sponsored by the campaign to abolish lead-free solder). ^^
Sign me up!

"...better for the environment..." tell that to the skips that had 11 dead Phat PS3's off me this year... seemed like a load of avoidable waste to me due to lead free solder.
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
A nice way to present in the info.

One bit of advice is to bend the pins over to hold the
component in place while you solder it. I've done this
myself in the past but be aware it makes de-soldering
the component much harder. I've worked on boards where
every component has had it's pins bent this way and it's
a total pain.

On balance I'd advise against this. Hold the component
in place with something that's heat resistant instead.
Or if the board is totally unpopulated then solder the
lowest profile components first and work up.
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,091CR
Pretty cool article. Is it just me that uses blu tack to hold stuff in place while soldering, then? If it gets too hot, it does kind of melt a bit, but is easy dabbed off with another ball of blu tack. I find it really useful, but maybe that's just me...
 

Flinnster

The Dino King
vacBacker
Feedback
29 (100%)
Credits
2,566CR
big10p said:
Pretty cool article. Is it just me that uses blu tack to hold stuff in place while soldering, then? If it gets too hot, it does kind of melt a bit, but is easy dabbed off with another ball of blu tack. I find it really useful, but maybe that's just me...

Shhh! trade secrets!
smiley36.gif
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,091CR
Flinnster said:
big10p said:
Pretty cool article. Is it just me that uses blu tack to hold stuff in place while soldering, then? If it gets too hot, it does kind of melt a bit, but is easy dabbed off with another ball of blu tack. I find it really useful, but maybe that's just me...

Shhh! trade secrets!
smiley36.gif

Damn. Sorry for letting the cat out of the bag.
smiley36.gif
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
smiley14.gif
I use blu-tac too, but it's not very heat resistant so I was
hoping someone might have a better suggestion.

(I wanted to avoid replacing one slightly dodgy practice with another
so I was deliberately non-specific)
Battlezone2016-11-28 16:40:49
 
Top