Taito Bubble Bobble missing green

insx

User
Credits
61CR
Hi Folks

I'm trying to diagnose a Bubble Bobble board (Taito/Romstar) that's missing its green output. I have a scope and I'm handy with a soldering iron but I do tend to need a bit of hand holding.

I've gleaned that it could be a faulty PC040DA module and this is the output from pin 3 on the red and green modules (red is fine).

Red_output.jpg


Green_output.jpg


As these are very similar, is this enough to establish that the green PC040DA is working fine and that the problem is somewhere downstream?

Thanks in advance.
 

John Bennett

Senior Member
vacBacker
Feedback
10 (100%)
Credits
5,324CR
It's probably worth changing the timebase so instead of looking at pixels flying out at 6MHz you can at least see a horizontal line's worth of data - 100us of pixels.
Looks alive anyway.

I've not got a BB board anymore, but it's just a ribbon cable and then some 75 ohm resistors after this, isn't it? Oh and a length of track and vias.

John Bennett2023-01-17 22:50:23
 

qjuk

Active member
vacBacker
Feedback
51 (98%)
Credits
2,079CR
I know it's stating the obvious, but have you cleaned the edge connector and checked pin 3 (video green) to make sure it's making good contact?
 

insx

User
Credits
61CR
Well... I thought I had checked the connections but it seems like the lack of green was down to a flakey JAMMA adaptor. Note to self: check and double check the simple stuff first. It was a right pain to fix because the adaptor was covered in hot melt glue so every time I dug away at it to fix something, I was in danger of breaking another connection or creating a short.
 

Monstermug

Active member
Feedback
23 (100%)
Credits
1,807CR
Yeah its very tempting to heat shrink and cover wires on jamma adapters to make it look neater but in the long run its a pita to fix and maintain. Also im notorious for skipping repair steps to save time just to cause more time in the end. Its also fun diagnosing non existing faults too. Loose a lot of hair in the process
 
Top