Tech question - Hantarex MTC 900 problem

philmurr

Active member
vacBacker
Feedback
48 (100%)
Credits
2,374CR
[ukvac] Tech question - Hantarex MTC 900 problem
Hi all,

I've got a problem with the Hantarex MTC 900 in my Robotron cab. It
looks like the red gun is stuck on all the time - can still see the
green and blue outputs on the screen, but it's overall red complete
with flyback lines. It did have a bit of a problem already where
the screen started blurred but cleared up after about 3 minutes of
being powered on - not sure if this is connected ?

Anyone know if it's a common problem, easy to fix ? There's a cap
kit ready to go in it but I reckon in this case that's not going to
do the trick. Or do I give up and try to find a replacement
monitor ?

Thanks a lot, Phil.
 

P-Man

International man of mystery
Feedback
4 (100%)
Credits
1,273CR
Re: [ukvac] Tech question - Hantarex MTC 900 problem
you need to get the tube on a rejuvenator to check it out.

the blurry focus problem tells me it may well be more than just a chassis
problem your tube could have an internal short between the red cathode and
focus grid.

You can try changing the red drive transistor on the neck board first to see
if that is your problem. You don't need a replacement just yet, just swap
the red drive transistor with the green drive transitor for example and see
if the problem follows the swap. If you get a screen of green then you know
its the transistor. If the problem doens't change then you need the tube
looking at.

It may well not be a terminal tube problem as a rejuvenator (if its any
good) should be able to remove the short on the red gun. If the focus grid
has lost continuity then its not the end of the world either, i have seen
several tubes with inoperative focus grids that still give a very focussed
picture. This is something that might drift over time, but i've not seen
them poop out just yet.

Andy Welburn
www.andys-arcade.com
 
G

Guests

Guest
[ukvac] Re: Tech question - Hantarex MTC 900 problem
I had a problem where I lost one of the guns completely on a 900E ( I
realise yours is a 900) .. think it was a red gun that was
inoperative.

A quick 'scopeless check was to just swap the red and green wires
over going to the neck board... this helped me work out if the fault
was on the main pcb or the neck pcb.

My fault turned out to be on the main pcb in the end with a blown
transistor.

Is it also posible the the red cut off has been tweaked ? I've seem
this before, especially if you have just got the monitor and theses
no "history" with it...

Cheers,
Colin
 
Top