Tempest mathbox

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
I'm currently having a pig of a job repairing a Tempest boardset with garbled perspective graphics and the obligatory 'M' in test mode, ie Mathbox failure. Have checked all of the usual suspects, swapped out the bit slicers, checked the PROMs, cable, connectors, blah, blah, blah.

My quest would be made easier if I have a fully working Tempest Mathbox PCB as a reference point - does anyone have one that I could borrow please, or at least that they could take logic logic probe readings from for certain chips?

Loan of working one would be best - I'll pay for postage each way and give you a few quid for the loan too. :)

Thanks in eager anticipation. :)
 

guddler

Busting vectors like it's 1982!
vacBacker
Feedback
10 (100%)
Credits
4,058CR
Probably a good idea if you at least set your location to tell us which country you're in
smiley1.gif
Preferably which area too.

Do you have access to a signature analyser? Thats quite a good tool for math box type errors.
 

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
I'm in the UK, but no worries, managed to fix it a few minutes ago ta so no need for a loan board now. :)

The mathbox had a bad 74LS08.
VectorGlow2010-08-14 22:33:06
 

VectorGlow

Active member
vacBacker
Feedback
34 (100%)
Credits
900CR
I used a combination of a logic probe and a 'scope on the outputs of all of the TTLs in the mathbox circuit and eventually found that pin 11 (if memory serves) didn't look quite right. An experimental piggy-back of a known good LS08 didn't help, but I replaced the chip anyhow and it fixed the fault. :)
 
Top