Trintron CRT problem?

G

Guests

Guest
Hey guys, sorry this isn't arcade related but I know you guys work with CRT's alot so i thought you might be able to help me.

Got a nice little 14 inch Sony Trinitron CRT today but it's arrived doing this:


Any ideas what could be the problem or is it a bin job?
smiley19.gif


rotunda2016-05-28 12:38:37
 

obcd

Active member
Credits
3,830CR
It's not very clear. I assume it remains all dead.

Some tv's start up in standby and need the remote to effectively turn them on.

You hear the degaussing coil doing it's job when you power it. Do you see anything else?

First thing to check would be the power supply. After that, you could check for a defective LOPT or HOT.
 
G

Guests

Guest
If you turn the volume up you can hear there is stuff going on. it's turning on so power supply should be ok. It's doing all the usual sounds just not starting the tube no static noises or picture on screen.

It arrived with it's cover damaged so it's taken a hit in transit I was just wondering if it can be saved as its a nice little set. These Trinitrons are getting abit hard to come by now.

I just heard Sony CRT's show error codes through the stand by light. Mine blinks once when you first turn it on and then again about 4 seconds later. apparently this is:

  • 2 times, Diagnosis: B overcurrent (OCP). Possible causes: H. OUT (Q8024) is shorted. (D board), +B PWM (Q8035, 8038) is shorted. (D board) Symptoms of the problem: Power does not come on, Load on power line is shorted.

rotunda2016-05-28 17:14:08
 

obcd

Active member
Credits
3,830CR
If it's just a transistor shorting the B+, it can be a cheap fix.

If it's the LOPT, it might be difficult to find a replacement.

You could try to desolder the HOT (probably Q8024) and measure it for a short.

That would be my first action based upon experience.
 
Top