TRON PCB info Needed

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
Battlezone said:
Hi Sarj,

It's a regular composite negative sync.

ok now thats confused me even more

the reason i asked this is because i had an ebay buyer buy my Jamma to Scart adaptor which is standard Sync

he said he wanted to connect his TRON PCB to it and has H and V Sync

so i suggested he also get a Sync Stabilizer that i sell to combine H and V to make it Composite

and hence why i asked in this thread about it

im very confused
 

silverfox0786

Beware the Hillman
Feedback
47 (100%)
Credits
2,699CR
a little more investigation brings me to finding this

Code:
J2 - 9 pin (MONITOR)
	
	1 - RED
	2 - GND
	3 - GREEN
	4 - GND
	5 - BLUE
	6 - GND
	7 - KEY
	8 - /HBLNK
	9 - /VBLNK

as you can see there is a H and V
 

Battlezone

Active member
Feedback
1 (100%)
Credits
410CR
Sarj,

My apologies for the incorrect info if they are split. I only checked one source

before responding. I checked the Tron manual rather than 'scoping

my machine because that felt easier.

Top of page 92 (8-7) "An interesting aside is that our sync is composite

negative sync. That means two things:

1. the sync is a negative going wave form.

2. There are two pulses going on at different speeds

over the same wire:

" etc

Maybe this section is talking about the monitor and the combining

is done before this (maybe in the loom).

Battlezone2016-07-30 16:42:20
 
Top