Which chassis is which?

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
Hey guys,

I sent a few monitors for repair and 2 of them came back as having dead tubes, so I asked them not to bother repairing the chassis.

When they came back, i asked him the state of the 2 chassis and he said "the 900 is dead and is not worth repairing, the other one works".

Now I am pretty sure that the 'other one' is a 900/e and i am hoping it is as I have promised it to someone as a 900/e , but would be grateful for confirmation. The other thing is I know nothing about chassis and got them confused so would be good if you could let me know which is which (so I don't give someone a faulty 900 instead of a working 900/e).

Pics below and what I think is what. Cheeers

What I think is 900 (the neckboard looks like it has a broken pin in it and the fuses look so corroded, I doubt that they are making contact).

Chassis11.jpg


chassis12.jpg


chassis13.jpg


chassis14.jpg


And what I think is 'the other one' (hopefully a 900/e)

Chassis21.jpg


Chassis22.jpg


chassis23.jpg


Cheers for all replies.
 

bbz149

Active member
vacBacker
Feedback
26 (100%)
Credits
1,608CR
The 900's are Dogs!! Had one in my Tron that I sent to Craig for repair that came back not worth repairing. The Spring prongs wear, the Tube suction Cups are like a hard Plastic and dont sit flush and the Focus Pot on the Neckboards are Pants. Binned mine
smiley21.gif
 

jengineer

Senior Member
vacBacker
Feedback
49 (100%)
Credits
1,205CR
I agree, the 900's are not worth repairing unless its in excellent condition, I think the 900 lopt's are very hard to get? someone might confirm this? and the chassis' have very corroded partsjengineer2016-01-18 15:11:11
 

tb2000

Active member
Feedback
4 (100%)
Credits
3,578CR
I have two hr lopts (did have three but used one refurbing a chassis ages ago) for the 900 chassis which do away with the resistor block behind the anode cup (the wire comes straight out of the lopt) and they use a standard anode cable/cup just like any other lopt. They are pretty difficult to find though. That said, I think you can get repro Chinese ones from the the USA but the ones I found were $100 each - the chassis aren't really worth that working!
 

simonden

Active member
vacBacker
Feedback
20 (100%)
Credits
1,042CR
yep on the 900 the tube suction cups are very hard plastic and out of shape, the prongs are now pure rust, the fuses and connectors are all completely corroded, board is dirty as hell, one of the pins on the neckboard looks like it has exploded.

Fortunately, the 900e is in good shape (and it is a 900e yay).

Will be offering the 900 in the free section for parts once i have taken off the wires/connectors.

simonden2016-01-18 15:29:14
 

Bensonrad

STILL looking for an Outrun & Paperboy!
vacBacker
Feedback
68 (100%)
Credits
940CR
and the next big questions is will the 900E fit on this 14" Cocktail monitor I have as seen in this post..
http://www.ukvac.com/forum/moon-cresta-table-montior-replace-or-repair_topic340705_post859527.html?KW=monitor+moon+cresta#859527
smiley2.gif
 
Top