Wiring Advice

sapporo46

User
Feedback
2 (100%)
Credits
70CR
Can anyone shed some light on this mains transformer in my cabinet? Originally only the two red wires from the bottom right of picture this were connected to power the monitor, but I've had issues with fluctuating voltages.

I unravelled the other wires and noticed they are significantly thicker than any others, even the mains wires! I've not put the multimeter on them yet, am a bit nervous though.

There are two of: blue, white, brown, black, red. The only clue I have is that the brown ones had a "lamps" sticker on them - but none of them have been connected apart from the red. Additionally, when I connect the earth from the transformer to the incoming mains, it trips the RCD.

Wiring_Craziness_1.jpg


Wiring_Craziness_2.jpg
 

obcd

Active member
Credits
3,830CR
Thicker wires are higher current. Usually, you only need high currents on lower voltages.

So, it's possible that the transformer has an additional 7VAC output and 15VAC output that could be used to produce 5VDC and 12VDC. You have a switch mode power supply to produce those voltages, so maybe that's why those windings are no longer used.

What issues are you having with fluctuating voltages? A monitor chassis needs an isolated 100VAC most of the time, but the input voltage is not very critical.

Is the earth a wire coming out of your transformer? Not sure where they would connect it to on such a torroid transformer. The only thing that could use earthing is the central bolt that fixes the transformer.

If it's your game board voltage that is unstable, it's probably not that transformers fault.
 

sapporo46

User
Feedback
2 (100%)
Credits
70CR
Thanks for the insight. After much faffing about and some help from a forum member, I disconnected the marquee light and I now get a solid 5.05V at the jamma edge when the game is running.

Going to replace the light with one of those 12V LED ones. As for those thicker wires, I think I'll just bunch them back up and cable tie them.

The earth wire does come out of the transformer, but when I got the cab it was looped back into the sleeve.

Cheers
 
Top