Zac invaders help

Body pop

Active member
vacBacker
Feedback
24 (100%)
Credits
1,266CR


Can anyone tell me what the grey going into the top connector on pcb does
It's came out and of the connector ,it's a wire but has two wires coming out of it ..I'm not sure what way round the go back in ? Also can those connectors be bought ?
Was just looking at the machine and the one bit of the wire has came out from left side of machine also

This is what it looks like at the min .though i did mess with the monitor pots initially
 

bbz149

Active member
vacBacker
Feedback
26 (100%)
Credits
1,608CR
Top pin of the 7 way connector Pin 1 is composite and the 7th pin is GND. The shield on that cable is the Gnd

Main%20PCB%20Schematic%20Bottom%20Right_zpsnyi8341r.jpg
 
Top