1943 pcb garbled

Ste72

Active member
Feedback
3 (100%)
Credits
152CR
I bought this board a while back but only recently got the chance to try it. As per the image, the graphics are all over the place, showing in parrellel at the side or top and bottom. Sometimes it shows dark bands. I've tweaked voltages and while the image changes, old problems go and new ones arrive!

Any thoughts or do I just sell-on as faulty? Voltages and pressing roms down so they are seated properly is about the level of my skills!

Thanks

Ste

1943-glitch.jpg
 

jonhughes

Active member
vacBacker
Feedback
52 (100%)
Credits
1,156CR
You may need to remove the ROM chips one at a time and gently clean the legs of any oxidation. I would invest in an IC chip leg straightener for when you put them back so the legs are all in line and you don’t bend chip legs under the chip. Make sure you don’t put the chip in backwards either or it will most likely fry it, chip notch to socket notch alignment only.jonhughes2023-01-30 12:48:36
 

John Bennett

Senior Member
vacBacker
Feedback
10 (100%)
Credits
5,325CR
I remember a PCB on here doing exactly the same as this, and I thought it was a 1943, but can't remember enough to search.
Is it just the text layer? Looks like it's getting the vertical count too early, then all that's left to draw is random garbage once it goes off the end.
 

Ste72

Active member
Feedback
3 (100%)
Credits
152CR
The sprites sometimes go with bullets coming out of nothing. I've reseated the ribbon cables too.

Will look into the 'leg tool' and rom chip cleaning.
 
Top