Not sure if this should go in this section - if not, Mods please shift it elsewhere...
I got a Wanhao 3D printer from t'lovely wife for my birthday and after modding it a bit to make it better than out of the box mediocrity, I have been busy on it with some pretty good results so far.
No arcade bits just yet, but there will be. Just for fun, rather than actual practicality.
Buttons, joystick balls, pcb feet, maybe even draw up a whole joystick?
I am currently working on making a Raspberry Pi Grrl Zero, like this - https://learn.adafruit.com/pigrrl-zero/overview
I managed to make the top part ok, which is the biggest print I've done so far, but inknown to me at the time, I was using a flexible PLA rather than the usual stiff stuff (Mother in law got the wrong product for my birthday!) But, it was okay as a proof part.
Here are some of the parts I have done so far...
I got a Wanhao 3D printer from t'lovely wife for my birthday and after modding it a bit to make it better than out of the box mediocrity, I have been busy on it with some pretty good results so far.
No arcade bits just yet, but there will be. Just for fun, rather than actual practicality.
Buttons, joystick balls, pcb feet, maybe even draw up a whole joystick?
I am currently working on making a Raspberry Pi Grrl Zero, like this - https://learn.adafruit.com/pigrrl-zero/overview
I managed to make the top part ok, which is the biggest print I've done so far, but inknown to me at the time, I was using a flexible PLA rather than the usual stiff stuff (Mother in law got the wrong product for my birthday!) But, it was okay as a proof part.
Here are some of the parts I have done so far...