ABI B4K Test Basic

martin8or

Newbie
Feedback
1 (100%)
Credits
144CR
I would imagine that the b4k is approaching its limits testing something like the 6809 (maybe it's too slow?), it's barely able to test a 6800 in fact I have 4 nos 6800's and they all fail no matter which pass/fail loop I use or sweep voltages. One of them will pass eventually on a fail loop but it takes about 10 mins to do it.

While I'm here, I am working on reverse engineering some protected 16R8's. Does anyone have the testbasic loader? I did write it down from screen-grabs I got from a youtube video but it's not working, I probably missed something out. I would like to be able to copy/paste code in a text document instead of nesting loops and then load it up. I'm not a programmer so I would like to try it one step at a time before I try optimising anything and typing the same line over and over is quite annoying while prototyping my code.

Cheers
Martin
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
Interesting every 6800 I've tested passed no problem. I wonder if it's to do with the manufacturer, I know someone had an issue with the chipmaster compact failing all z80s made by a certain manufacturer even though they worked fine.
 

martin8or

Newbie
Feedback
1 (100%)
Credits
144CR
I just had a quick squiz now and could only find 2 of them.

They're Motorola MC6800P dated 25th week of 83 and 15th week of 82. I also found a note that I had forgotten about which said that I could get one of these 2 6800's to pass after about 5 seconds on a fail loop if I added a 0.1uf cap across the power pins like it mentions for the TMS9995 . They have been tested as working in actual equipment.
I used to have a chip-master. It probably can't provide enough juice for a hungry old z80?

Cheers
Martin
 

martin8or

Newbie
Feedback
1 (100%)
Credits
144CR
Just got one of these from China as they were so cheap.
http://www.ebay.co.uk/itm/SOP16-SOIC16-to-DIP16-IC-Tester-Socket-Programmer-Adapter-ZIF-1-27mm-Pitch/202041725139?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2057872.m2749.l2649
Took less then a fortnight to get here. Quality is fine. Good for testing the smaller stuff in the B4K.

Saw this too but I haven't bought one yet. Might be useful for clipping into the normal in-circuit test leads?
http://www.ebay.co.uk/itm/Programmer-Testing-Clip-SOP-16-SOP-SOIC-16-DIP16-Pin-IC-Test-Clamp-Cable-hot/321899798260?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m1438.l2649
 
Top