Address line help

bones

Active member
Feedback
15 (100%)
Credits
1,628CR
John Bennett said:
1/R = 1/R1 + 1/R2 + 1/R3...

So: 

1/R = 1/1000 + 1/270

1/R = 0.004703

R = 212.6 Ohms.

Pretty much bang-on
smiley4.gif
my God, I'm embarrassed,cheers John.
 

ColinD

Active member
Feedback
6 (86%)
Credits
1,367CR
bones said:
The address line short did turn out to be a tiny solder bridge which is now ok. I could barely make it out even with the magnifier light thing I've got

Nice. So, did this come to you faulty or was it working and suddenly went wrong ?

When boards are faulty, I'm always suspicious, especially if people have worked on them before !

I can see why certain repair places won't touch boards that have been worked on.... (Such as Pinballs and Monitors).
 

bones

Active member
Feedback
15 (100%)
Credits
1,628CR
I bought as working many years ago and naively put it into storage without testing so I'm unsure whether it was good or bad. Either way I thought I'd use this board to learn how to actually use my digital scope. I did go over it with the old logic probe but the digital scope set on dual trace testing simple octal buffer chips and inverters like the ls04's has opened my eyes. Seeing the signals going into double input gates where one input is tied HI and viewing the same signal output is great, loving it. I've got lot's I don't understand like some of the ls86's seem to invert the output signal compared to one of the inputs but I'm assuming that the second input is responsible for that.
This PCB definitely has one faulty 4116 ram on it at the moment which the scope showed a different output signal on pin 14 as opposed the 7 others so I swapped positions and no matter where it went it had a different output to any of the others that were in this position. Ok not a biggy to some but new to me. It's found me 2 ls161 output signals that were awfully distorted and both tested bad once removed from the PCB. Also found 2 ls373's with terrible looking signals coming out, they even tested ok when removed but some new ones gave lovely clean looking outputs,no idea why.
Still can't navigate changing the time base manually so I'm hitting the auto setting button as I go. I can't remember the gate but one input was a continuous signal and the other was a square wave of a certain length and the output was a piece of the continuos signal confined only to the length of the square wave, I guess this is super important in regards to timing.
Anyway, it's still not working but I'm enjoying seeing the signals looking better when I change a chip lol. Rewarding compared to beeps and flashes.
 

Lurch666

Active member
Feedback
21 (100%)
Credits
4,507CR
The LS86 is an exclusive OR gate which means if the the two inputs are the same the output is low and if the two inputs are different then the output is high.

INPUTS OUTPUT

A B

0 0 0

1 0 1

0 1 1

1 1 0
 
Top