AMP universal power extractor tool

chris2922

Active member
Feedback
1 (100%)
Credits
333CR
Hi all. I need an extractor tool for TE connectivity AMP universal power connectors. Used a lot in SEGA cabs from the 90’s.

I have built a few male and female connectors with no problem but my last attempt won’t plug in all the way. One of the contacts must have gone in at slightly the wrong angle. The plug actually works because it almost plugs all the way in - but not properly and I’m not happy with it.

I have looked at the proper TE extraction tools on Radio Spares are listed at ridiculous prices!! Three Grand for a little plastic handled poking device?! Crazy.

I’ve had a look on eBay and there are lots of generic sets for all sorts of contact types but I want to make sure I can work with AMP UP.

I’ve seen a few on eBay that are for ‘AMPLIMITE’ but I don’t know what that is!
EXTRACTION-TOOL-SERIES-2-FOR-USE-WITH-AMPLIMITE-CONT-FOR-AMP

Anyone got any experience of working with AMP UP or have a good tool they can recommend?
 

channel27

Active member
vacBacker
Feedback
12 (100%)
Credits
1,377CR
These connectors?
https://wiki.arcadeotaku.com/w/AMP_Universal_Power

If so, unfurl a paper clip and poke it into the back of the connector above the wire. You'll feel it go into the hole above the crimp and you should be able to pull the wire out with the crimp attached.
 

big10p

Coins detected in pocket!
vacBacker
Feedback
13 (100%)
Credits
6,092CR
It's always a good laugh looking at the prices of specialist crimping and extraction tools. As above, I just use whatever's to hand to best do the job, such as a paperclip.
 

channel27

Active member
vacBacker
Feedback
12 (100%)
Credits
1,377CR
https://www.youtube.com/watch?v=PcJUhtHCzfI

smiley20.gif
 

FrancoB

Active member
Feedback
17 (100%)
Credits
1,040CR
Yep, a paperclip works great for this. In the video above he recommends to use a thick gauge paper clip but I found just a 'standard' paper clip works spot on.
 

Chopper79

Active member
Feedback
8 (100%)
Credits
668CR
Don't waste your money on those tools. I've removed hundreds with a tiny flat blade screwdriver. Once you know where the locking tabs are, they come out in seconds.Chopper792022-02-21 14:06:19
 
Top