Anyone fix Surface mounted PCBs ? (Maximum Force)

BGOllie

User
Feedback
2 (100%)
Credits
29CR
Hi,

I have a non booting Maximum Force PCB (PWR/RST led flashes on and off) . It's all surface mounted technology and well outside by ability to diagnose and fix .

Is there anyone who can fix these on here ? The pcbs seem tricky to find so I'd rather get it fixed.

Ollie
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
Are you sure it's a problem with the pcb and not the hard drive? If it's anything like killer instinct it won't boot without a working hard drive connected. Using a cf card / adaptor rather than an old mechanical hard drive is the best option.
 

BGOllie

User
Feedback
2 (100%)
Credits
29CR
it's got a CF card conversion kit installed already. Voltages seemed fine on the card connector so I assumed it wasn't the issue. I didn't check the contents of the card (assuming is this "standard" windows file format ? )
 

Ace`

PlanB contributor #1
Feedback
40 (100%)
Credits
4,038CR
Finding someone that can surface mount solder is only half the battle, most of the chips are going to be custom and or hard / expensive to find.
smiley11.gif


You could carefully go around the chips with a toothpick pressing lightly on each pin to see if any are loose. As that's a common issue with smt chips, after that I'd say it'll be cheaper to buy a board from the states rather than trying to get it repaired.
 

AaronBoone

Active member
vacBacker
Feedback
3 (100%)
Credits
165CR
One has just popped up on eBay if you don't fancy messing around with the one you have http://www.ebay.co.uk/itm/182597747551 (sorry struggling to link from my phone). Don't know if that's a good price or not but you can always shove an offer in.
 

Bods

Senior Member
vacBacker
Feedback
5 (100%)
Credits
5,414CR
Might be in same boat after the battery leaked in our Jungle Jive machine, gone right down the pcb to the Surface mount IC which isn't good news

I used to do some Surface mount work when repairing computers, so may have to invest in the tools myself as I ain't got much chance getting replacement board

Repaired a knackered Grabber PCB not long back because the damn battery had leaked on that, managed to find a few tracks that it had eaten through
 
Top