Just wondering if anyone out there has had any experience with Mektek 3 Coin Mech Programmers at all?
I have Zero Experience. However thought i would give it a go following the instructions on a Coin Controls C220Mech (Alias "Sentinel") - the one found in most 90's pinball machines....
So - started from scratch using a coin template, and then learnt every coin manually (£1/50p/20p/per 2010 10p)... All thrown through, estimated 98% - 99% acceptance. Widened the windows a little, and this increased to 100% on some, 99% on others - which is good for me.
Wrote to the unit.... Back into Validate... Sees hardly any coins at all (Maybe one or two out of each type Max when 20 put through).
Anyone any advice or help at all please??
Cheers
Paul
I have Zero Experience. However thought i would give it a go following the instructions on a Coin Controls C220Mech (Alias "Sentinel") - the one found in most 90's pinball machines....
So - started from scratch using a coin template, and then learnt every coin manually (£1/50p/20p/per 2010 10p)... All thrown through, estimated 98% - 99% acceptance. Widened the windows a little, and this increased to 100% on some, 99% on others - which is good for me.
Wrote to the unit.... Back into Validate... Sees hardly any coins at all (Maybe one or two out of each type Max when 20 put through).
Anyone any advice or help at all please??
Cheers
Paul