Arcade controls sharing

terminator2k2

Active member
Feedback
1 (100%)
Credits
327CR
Hi there, my plan was to allow my pc mame machine , share the same controls as my arcade Jamma controls.

So I split the cables from the sticks and buttons and connected them to a ipac 2.

So far so good. I wasn't planning on running both systems at the same time, so thought this would work.

Any way with the PC off, the original Jamma works fine, now with the PC on and the Jamma power supply turned off, the ipac 2 doesn't want to work.

If I disconnect the Jamma connector from the game pcb and then start up the mame PC, everything works on the ipac 2.

Any one got any ideas?

I wanted to get this set up with a simple on/off switch , to switch between the Jamma power supply or the PC power supply.
 

obcd

Active member
Credits
3,830CR
Probably your game board is drawing current from the ipac inputs so that the voltage drops. Measure the voltage on a switch with and without the game board connected. (switch not activated as it will be 0V when the switch is pressed.)

You could try to install some BAT85 diodes on the input lines coming from the jamma and those coming from the ipad. They will prevent current flow from the ipac to the jamma. The BAT85 is having a low treshold voltage. 1N4148 might also work. Even 1N4007 is a possible candidate if the 0.7V treshold isn't a problem. The diodes need their kathode connected to the switch. You will need one for every input. The anode of the diodes should be connected to the input wire going to the jamma.
 

terminator2k2

Active member
Feedback
1 (100%)
Credits
327CR
hi there, its 1.2v with the game board connected and 4.9v disconnected.

so I take it the ipac is seeing all the switches as a short circuit due to the logic level being low.?
 

obcd

Active member
Credits
3,830CR
Yes, it should see it as all the switches are pressed.

Farnell and RS components sell those BAT85 diodes. Just try it out starting with one input (and measure the voltages again with that diode installed. So basically, the kathode is connected to the switch and the anode is connected to the Jamma input wire (that was connected to the switch)

So, basically, the switch can still pull the game board input to ground but the game board can't pull the ipac voltage to ground.

If you have some other diodes lying around, you might try with one of those. The game board input voltage will still be 0.7V when a switch is pressed if you use a si diode. Maybe the gameboard won't detect the switch anymore. You can't damage anything by testing like that.
 

terminator2k2

Active member
Feedback
1 (100%)
Credits
327CR
hi there, got my diodes , fitted them and all is well....no need for me to unplug the jamma cable...

voltage is really low now on the jamma connector, around 0-0.7v when jamma pcb switched off.

jamma controls works and so do ipac2...well happy...
 
Top