Arcade Maintenace: cleaning tips

Nes4life

Active member
vacBacker
Feedback
12 (100%)
Credits
1,134CR
What tips you guys got to clean cabs and get them in tip-top condition?

Gunblade encouraged me to get some windowlene / glass cleaner for my monitors as he was working on a tube and couldn't get a sharp picture; the reason being that I'd never cleaned it before! I got inspired (after being shamed), opened up my cabs and started a deep clean. All glass was removed and cleaned both sides, all monitors wiped down, and the bottom of the cabs vacuumed to infinity. The difference is amazing! I can actually see the games now!

So come on guys, what's your routine? What do you do to a newly acquired cab and what products do you recommend?
 

muddymusic

The Repro Guy. Art and Parts supplier
Staff member
vacBacker
Feedback
52 (100%)
Credits
2,265CR
Usually the same routine for me on every cab.

First up a good hoovering with a narrow nozzle in the base, then with the soft brush attachment.
If it needs it I take everything out, so monitor and pcb etc and give them a Hoover too or a brush outside.
Polish the inside. Magic eraser over sides and control panel. Finally work some Novus 2 & 1 on the bezel and marquee.
 

t-m

Active member
vacBacker
Feedback
2 (100%)
Credits
333CR
I cleaned the monitor and glass in a cab yesterday and now the brightness needs turning down a bit
smiley3.gif
 

grobda

"Look at the size of that thing!"
vacBacker
Feedback
7 (100%)
Credits
1,061CR
Vacuum cleaners can build up impressive charges of static electricity. Your ram chips may take issue with this

Just sayin

Cue someone to say 'I've been vacuuming PCBs for years and never had a problem'
smiley36.gif
 

muddymusic

The Repro Guy. Art and Parts supplier
Staff member
vacBacker
Feedback
52 (100%)
Credits
2,265CR
I've vacuumed pcb's at least once maybe twice and only had one maybe two go bad.

That better?
smiley36.gif


I don't vacuum the game pcb's - I mean psu and monitor, and brush the pcb and chassis with an anti-static brush if they have mega-filth.

Vacuuming a pcb can have other side effects like, oh whoops there goes a loose eprom and some caps.
 

obcd

Active member
Credits
3,830CR
For the pcb's, I use an air compressor to blow the dust away. The dust is normally very dry and blows away easily. Doing like that, you don't have to touch anything. If your eprom labels are real old, you might blow them off. Some extra Transparent piece of scotch tape can prevent this. Some compressors build up static voltage as well, I have once seen a sparc from the compressor nozzle to the pcb, and the result wasn't fine. As long as you keep the nozzle some distance from the pcb, and make sure it can't use the pcb as discharge path, you should be fine.
 
Top