Asteroids PCB delayed reset and hum

Nes4life

Active member
vacBacker
Feedback
12 (100%)
Credits
1,134CR
After some advice hunting down an Asteroids PCB fix (on the bench):

Symptoms:

  • Loud continual hum
  • Game resets after about 10 seconds of attract mode (time varies)

Investigation:

  • Let's look for the hum!
  • Pulling R7 (LS08 used in the explosion sound) stops the hum completely but game still resets after a few seconds. R7 validates.
  • Replaced R7 -> pin 1 is HIGH (ExpAud0 is being triggered?)
  • P7 (LS174) pin 12 is HIGH (ExpAud0 is being triggered)
  • Pulling P7 does not stop hum
  • P7 validates.
  • N6 (LS32 OR), L5 (LS04 NOT) and D6 (NAND) all working as expected
  • P8 (LS161 counter) inputs 3,4,5,6 are H,H,L,H (P8 inputs on a woking board: L,L,H,L)
So I currently conclude that P7 is actually bad or it is being given bad data. I don't have a LS174 to hand (although p7 is already socketed).

How would you check for bad data / inputs on P7?
 
Top