Asteroids pcb

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Picked up a asteroids pcb that is supposed to be a worker from an op today.
When tested I get red led on board and p1 and p2 LEDs stay lit.
No picture or sound apart from a loud hum.
It won't go into test mode.
I have tried reseating all the sock chips but no change.

Any idea's?
I now have 3 faulty asteroid pcbs!!!!!!!

Steve
 

forcefulfil

EDOT King
vacBacker
Feedback
17 (100%)
Credits
1,675CR
Steve i did a trade with Nad for the above
ferkin rock solid PCB better than a repair that dies in a few hours as asty,s can do

they need a lot of work to be reliable

vectors are fun IF you can do a lot of stuff yourself otherwise they can be a pain

forcefulfil2014-08-25 19:42:24
 

Equites

Chief Sheesher®
vacBacker
Feedback
35 (100%)
Credits
3,329CR
I recommend Mark of retroclinic for the repairs, he also offers limited warranty with his work.

I'm too busy for any repairs right now.
 

david_orton_2000

Green Mario
vacBacker
Feedback
8 (100%)
Credits
344CR
Hi Steve,

Can you do any electronics testing?
What test equipment do you have?
Do you have an Rom reader, i.e. so you could at least dump the Roms and check them.
Next would be the 2114 Rams, which are normally soldered, these can go due to age/heat, etc.
Further than that, it is logic probe, scope and fluke time!...which is time-consuming for anyone.

Does your working pcb go into Test mode?
For the non-workers, when choosing test mode, do you hear any beeps (like the old PC Bios beeps).
-this can give further diagnostics, etc.

I also have an Asteroids cabinet and 2-3 broken pcbs, which I will get around to fixing at some point.
I have fixed mine twice, however it could be anything.
-I am not that far from you (Aylesbury), so maybe we could do a tech mini meet at some point?

Cheers,
DaveO.
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Hi, as far as board repairs go I have no experience or any test equipment apart from a multimeter
I will try working board to see if it goes into test mode.

You are welcome to pop round anytime and play some cabs if you like.

Cheers,
Steve
 
Top