Asteroids playing blind

bud2

Newbie
Credits
24CR
Howdy,
so I have an asteroids playing blind.
Symptoms:

1) game plays
2) spot killer is OFF
3) all voltages to deflection are correct
4) X,Y and Z at deflection board ( well, fluctuating voltages as per some advice from another site)
5) Deflection board examined nothing obvious
6) HV board examined nothing obvious

advice etc most welcomed.
thanks
 

pooman2084

Be Attitude For Gains!
vacBacker
Feedback
26 (100%)
Credits
1,886CR
Thanks for the post, this inspired me to try and sort my Asty DLX as I have a similar symptom.

After finding the best way to get at the monitor is actually through the coin door, I removed and checked each fuse. We'll blow me if there wasn't a dead one. Hopefully this will be the fix rather than the symptom of something else.

My PCB is currently on holiday with Nad as he checked it out for me, but I'll post back when I get it with the results.

I've had nothing but bad luck with vectors over the years, so I'm hoping for some success here... :)
 

bud2

Newbie
Credits
24CR
Hey,
ok, if there is anybody in the Staffs / Derbyshire/ South Cheshire area that can give me guidance on this then I will gladly pay the going rate, I am happy to collect and deliver you back to your abode :)
 

DanP

Administrator
Staff member
vacBacker
Feedback
5 (100%)
Credits
2,232CR
Assuming it's a g05 802 I'd say start by reflowing the solder on all the connector pins. This also assumes that the PCB is working correctly of course.
 

bud2

Newbie
Credits
24CR
The monitor and deflection board is this;
http://%20arcarc.xmission.com/PDF_Monitors/Wells%20Gardner%2019V2000%20XY%20B&W.pdf
Already ref lowed the pins etc
The board is working.
Wish I new more
 

bud2

Newbie
Credits
24CR
Hi ,
No white spot, isn't the spot killer supposed to prevent this
From burning the phosphor crt layer ?
Cheers
bud22016-05-24 21:33:01
 

bud2

Newbie
Credits
24CR
yup, the spot killer led is off.
I thought the spot killer being off was saying," yay, eberything is ok ok here, you have an x,y,z siganl and the voltages look fine"
I dunno , maybe Iam wrong?
please, I am kind of not sure abouit these things.
BUt, from what I see in the schematics and other literature, vector monitors seem alot easier to understand than their rasrter conunterparts.
Again , I am no expert. :)
 

pobtastic

Moderator
Staff member
vacBacker
Feedback
2 (100%)
Credits
477CR
Spot killer comes ON when it's active (meaning it's "killing yo spot"), hence yes as mentioned ~ it probably is the HV diode at fault. Not an uncommon failure ...
 
Top