Finding myself needing a nudge in the right direction on Asteroids vector side.
Board powers up, have done all RAM/ROM tests, all pass, clock is fine etc. Here's the mess I see on the test screen:
I'm taking a few wild guesses here about what might be going on.
1) State Machine is not reading vector RAM properly thus getting rubbish into the drawing routines.
2) Counters in either the timer or x / y routines are bad.
3) I don't think its the analog side of it as what it is drawing is stable in both directions and I have control over the X/Y sizes.
Having a bit of troubling homing in on where to go here.
I started at the beginning of sheet 2A in the schematics and found I had nothing on one of the ADMAx signals but then I compared it to the board I sorted out the other day and that was exactly the same.
Anyone can help with any theory on this?
Thanks
Board powers up, have done all RAM/ROM tests, all pass, clock is fine etc. Here's the mess I see on the test screen:
I'm taking a few wild guesses here about what might be going on.
1) State Machine is not reading vector RAM properly thus getting rubbish into the drawing routines.
2) Counters in either the timer or x / y routines are bad.
3) I don't think its the analog side of it as what it is drawing is stable in both directions and I have control over the X/Y sizes.
Having a bit of troubling homing in on where to go here.
I started at the beginning of sheet 2A in the schematics and found I had nothing on one of the ADMAx signals but then I compared it to the board I sorted out the other day and that was exactly the same.
Anyone can help with any theory on this?
Thanks