atari hall effect sticks replacing.

Rone

Active member
Feedback
4 (100%)
Credits
90CR
hi Folks, here we have got a other escape from the planet robots mashine, orig atari again. it is a Project for next time, so i thought about replacing this hall effect sticks totaly. has anybody done this? with what Kind of sticks? does it Need a lot re-wireing in the cabinet? can you please Point me in the right direction here!
it is the orig atari cabinet pcb, not the jamma conversions cabinet pcb.
thanks to all.
 

ColinD

Active member
Feedback
6 (86%)
Credits
1,367CR
I'm told by Andy at Ultimarc that his ultra stick can be supplied 'factory set up' to output an analogue signal as standard, with no messing about with usb or config software.... so this might be a viable drop in replacement.

https://www.ultimarc.com/ultrastik_info.html

These are under £40.

They have a 10 pin header... so will need 5v and Gnd and you get the two analoge axis out on another couple of pins, but these are not supplied as standard to do this, so you need to ask him to set this up for you !!




He should be able to provide a harness too.... so will be 4 wires to hook up.

Please let us know how you get on and mention that I send you, but please be aware that your mileage may vary as this has not been tried before afaik with Atari Game Boards.

Can anyone confirm the Voltage Output ranges on the origonal atari sticks ????

Thanks, Colin D

ColinD2017-01-09 20:16:43
 

Rone

Active member
Feedback
4 (100%)
Credits
90CR
i just need go to the cabinet, then i know the voltage! Hey Mate, thank you very much for all this info! Will contact him tomorrow! ... Yes i let youv know how this goes forward...
 

Rone

Active member
Feedback
4 (100%)
Credits
90CR
or is there a "easy" way to replace the original hall effect sticks with "Standard" digital, 4/8 way sticks (micro-switch sticks)? Rone2017-01-10 07:56:30
 

GadgetFreak

Active member
vacBacker
Feedback
7 (100%)
Credits
963CR
Road Runner has variable speed so replacing with a digital stick would affect game play.
Atari used the analogue inputs for Peter Packrat & Indiana Jones digital sticks but each direction went to a separate channel and were 5v common except for the cockpit Indiana which used 0v common.

So as RR only uses 2 channels you would need a circuit between the stick and the main board to generate either low, middle or high outputs for each axis.
 

iamjimmi

Active member
vacBacker
Feedback
8 (100%)
Credits
498CR
All I know is that Road Runner and I,Robot are unplayable in Mame with a digital stick.

Actually I do know something else... when those Atari Hall effect joysticks come up, they are bl##dy expensive!
 

Alpha1

Do the Shake and 'VAC
Staff member
vacBacker
Feedback
95 (99%)
Credits
5,653CR
You can use ordinary sticks - someone on KLOV made an adapter PCB you have to wire the joysticks up to, then the adapter connects to the PCB.
 

GadgetFreak

Active member
vacBacker
Feedback
7 (100%)
Credits
963CR
You can hook up a standard micro switch joystick by just connecting the Y axis (pin 2 J102) to the Up & Down switch common and the X axis (pin 3 J102) to the Left & Right switch common.
Then you connect +5v to the Down & Left switch normally open contacts and 0v to the Up & Right switch normally open contacts.

But as previously stated, the game is not very playable as you will always be moving at full speed.
 
Top