Atari system 1

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Hi, tried some. Ore testing on my system 1 cab.

The marble madness cart keeps saying bank switch error, any ideas?

I have a tried a known working slapstick but no change.

Looks like it could be a faulty ram or rom circuit. Any pointers where to look?

Thanks,
Steve bonehead2017-01-10 23:21:50
 

Purity

The Oracle
vacBacker
Feedback
17 (100%)
Credits
2,999CR
bonehead said:
Hi, tried some. Ore testing on my system 1 cab.

The marble madness cart keeps saying bank switch error, any ideas?

I have a tried a known working slapstick but no change.

Looks like it could be a faulty ram or rom circuit. Any pointers where to look?

Thanks,
Steve

I have never looked at a System 1 PCB but I would assume bank means data bank, and switching means, it is swtiching between rom data.

Looking at the manual it says "If the bank switch ROM circuits on the cartridge PCB are faulty, the message bank switch error will appear"

So based on that I would:

1) Put the game in self test and see if there are any rom or ram errors (see manual)
2) Reseat the roms, and check them for any damage, corrosion or bent legs
Purity2017-01-10 23:45:27
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
Thanks,
I have tried re seating and cleaning the chips but will look again tomorrow. In test mode it won't go any firther than banks switch mode. If you press player one it resets and says the same bank switch error.

Thanks
 

Macro

Active member
vacBacker
Feedback
4 (100%)
Credits
2,010CR
bank switch error normally means the slapstic is dodgy

check that there are not any shorts on the pins under the cartridge, I have found that the socket pins bend over and touch tracks (and Atari use naff solder mask) so it shorts things out - have fixed 4 or 5 carts by doing this!

if it is the slapstic, then there is Colins multi-slapstic, or I may have a couple of marble madness ones in the spares box (110 from memory)
 

bonehead

I'll get pix tonight
vacBacker
Feedback
50 (100%)
Credits
1,729CR
That's a good link, thanks. Need to get a couple of chips burned at those locations to see if it helps. None of the board looks that clean so I guess the fault could be anywhere!!!
 

Bods

Senior Member
vacBacker
Feedback
5 (100%)
Credits
5,413CR
The Atari Manuals are the best of any I think

Really give you helpfull info, even about replacing IC's, Sega ones show all the parts etc but don't tell you much I feel, damn good machines though
 
Top